Service Support|Moon Automation Technology

Common Problem

Q

Filling method

A

Our current filling methods are as follows: (1) Plunger pump (2) Time pressure (3) Peristaltic pump (4) Flowmeter (5) Diaphragm valve Please select the filling method suitable for your product according to the applicable conditions and filling accuracy requirements. For details, please refer to the file on the applicability of filling methods uploaded by our company.
Q

Filling drip

A

In the filling process, liquid medicine drop is a problem that often occurs. On the one hand, it will affect the filling accuracy of our products, and on the other hand, it will also affect our production environment. Under normal circumstances, when filling drip occurs, we can deal with the following aspects: (1) Adjust the re-attraction in the formula. Note that the bigger the better, you can insert a transparent silicone tube into the needle, and look at it to suck up about 3MM. (2) See if our actual product characteristics are low density and viscous. This kind of product cannot be filled with a plunger pump to achieve re-suction. It can only be filled with a peristaltic pump. This is because of the plunger pump. The tightness is not as good as that of a peristaltic pump. (3) Check whether the slow filling position is too high. If the liquid level of the slow filling exceeds the liquid inlet of our pump too much, there will be liquid level pressure at the needle position, causing dripping.
Q

Filling accuracy

A

Filling accuracy controls the quality of the product during the production process. Different filling systems correspond to different filling accuracy. We need to analyze whether our equipment can meet the requirements of actual product accuracy. Several factors affecting filling accuracy: (1) Filling drips. (2) The filling system, including the filling needle and the filling hose, will affect the filling accuracy. It is necessary to select the appropriate silicone hose corresponding to different loading volumes. (3) The filling curve adjustment in the formula is generally adjusted according to the water when the equipment leaves the factory. Since the characteristics of the filled product and water in actual use are different, it needs to be re-adjusted according to the product.
Q

Other problems

A

if you have more questions, please let us know in the message feedback, we will solve and answer you as soon as possible.